DIY Refilling a dead Ink Jet Printer Cartridge

Material Needed

Refilling Ink Black + Color

Medical Syringes with Needle.

Blade.

Electric Insulation Tape/ Any adhesive tape.

PCB driller + 1mm drill bit.

 Remove the Label on the Cartridge. This is a color Cartridge.

 It has three tanks.

 Keep Drilling near the air hole. Once the hole is drilled, you can pull out the drill bit. Now note down the color of the drill bit. Residue ink inside the cartridge will stick to the drill bit. You need to fill the corresponding color to each tank.

 Inject the correct color. Once you are done injecting all the color inks, you need to cover the hole with the adhesive tape.

 Calibrate the Cartridge inside the Printer and go with a test run.